Article Views:
203
Ezine ready page
Ezine ready page
Posted on November 22, 2008 by Pearle Tsuji | Posted under Interior Decorating
Drywall Mud: Mudding A Room
|
There is not just a type of drywall that is sold in stores. According to your own needs, choose drywalls of the necessary width and type. There are two possibilities in case your walls are in a state of disrepair. You can put some new drywall, or you can choose to apply a thinner drywall over the walls, to give them that nice look you have been searching for. Still, you may discover that you will end up paying the same amount of cash, so choose wisely. Use a drywall lift to hold the drywall against the ceiling, while you screw it into the panel. Rent a drywall lift to help you with this stage. Remember to place the needed type of drywall, like moisture resistant drywalls in the bathroom. Here is another tip: for tub surrounds and showers, you will need some cement board and not drywall. This will not be able to resist to the quantity of water involved. There are also drywall rules and regulations in each state, so you will need to consult before doing anything else. All the drywalls must be well screwed in place, so they do not move from the walls. A countersinker can help you screw the drywall the way it is intended, to avoid further complication. Also, invest in some special drywall screws, as they are much better then nails. In places where the drywalls encounter each other, try to adjust them so they meet as perfect as possible and cover the portion of interaction with a bulk of mud. Remember to schedule an inspection of your work from the municipality, before getting along with the mudding part. Now, with some ready mix mud, you can begin the work. You may be a little confused, seeing how many types of mud exist on the market, but we suggest you to try the all purpose mud to make the first covering of the drywall and to use a light mud for the final layer. This type of mud has the ability to make less bubble and it has a nice and smooth appearance. When you stir the mud, make sure that you avoid making bubbles. These bubbles of air will appear on your final work and that will not be very pleasant for you. It is advisable to use some plastic knives for these walls, but they must be checked for burning signs, but metal knives are worse, as they can rust and ruin your work. Here is how you apply the mud: with plenty of it on your knife, start pressing it into the seam between the drywalls. Fill it to the brim, and then smooth the surface; with a bright light, you can see at which angle it will be best to apply the mud. The paper tape for the drywalls must be cut in threads of the needed lengths, with some extra on each end. If you want, you can soak the tape a little in water, but be prepared for the mess you will produce. Specialized tape is always recommended, as other types can ruin your work. For inside and outside corners, never use mesh tape, as it will not fold well. The tape must be applied over the mudded wall with the hands, with the tape well centered on the seam between the drywalls. The knife must be kept clean all the time, if you do not want to make a mess. Press well with the knife, so that the mud gets into the tape; any signs of bubbles must be flatten with the hand. All the mud that gets out of the tape must be removed with the knife. After you finish this stage, let the mud dry for one night and continue afterwards. Small cracks or the holes made by the screws must also be covered with mud. About The Author: Visit www.articleclick.com for additional article contributions by Pearle Tsuji. |
Tags:
